PolyBrite 5.5mil Non-Adhesive Clear PET Film

PolyBrite 5.5mil is a glass-clear, PET film with a high-gloss printable surface on one side and a non-printable anti-static backing. It is NON-adhesive. It is highly stable and heat-resistant. As with all films, this product must be allowed to off-gas after printing. This can be achieved by leaving the prints face up, ideally 24 hours, to set and harden the unique scratch resistant properties. If unable to do this e.g. with a long print run, after printing the roll stand it vertically and loosely unwind as much as possible, to allow air in and gases out.

This film is compatible with solvent, eco-solvent, UV-cure or GEN-3 or higher latex printers.